hda: FUJITSU MPA3043ATU, ATA DISK drive
hdc: ST34321A, ATA DISK drive
hdd: LTN202, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
blk: queue c031ece4, I/O limit 4095Mb (mask 0xffffffff)
hda: failed write cache flush, disabling ordered write support
hda: 8544940 sectors (4375 MB), CHS=4238/32/63, UDMA(33)
blk: queue c031f054, I/O limit 4095Mb (mask 0xffffffff)
hdc: safely enabled flush
hdc: 8404830 sectors (4303 MB) w/128KiB Cache, CHS=8894/15/63, UDMA(33)
hdd: no flushcache support
hdd: ATAPI 21X CD-ROM drive, 120kB Cache
Uniform CD-ROM driver Revision: 3.12
ide-floppy driver 0.99
Partition check:
 hda: hda1 hda2
 hdc: hdc1 hdc2
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
loop: loaded (max 16 devices)
Cronyx Ltd, Synchronous PPP and CISCO HDLC (c) 1994
Linux port (c) 1998 Building Number Three Ltd & Jan "Yenya" Kasprzak.
ide-floppy driver 0.99
SCSI subsystem driver Revision: 1.00
request_module[scsi_hostadapter]: Root fs not mounted
request_module[scsi_hostadapter]: Root fs not mounted
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
 [events: 0000001f]
 [events: 0000001f]
md: autorun ...
md: considering hdc2 ...
md:  adding hdc2 ...
md:  adding hda2 ...
md: created md0
md: bind<hda2,1>
md: bind<hdc2,2>
md: running: <hdc2><hda2>
md: hdc2's event counter: 0000001f
md: hda2's event counter: 0000001f
md: md0: raid array is not clean -- starting background reconstruction
md: RAID level 1 does not need chunksize! Continuing anyway.
request_module[md-personality-3]: Root fs not mounted
md: personality 3 is not loaded!
md :do_md_run() returned -22
md: md0 stopped.
md: unbind<hdc2,1>
md: export_rdev(hdc2)
md: unbind<hda2,0>
md: export_rdev(hda2)
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind 2048)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 120k freed
 [events: 0000001f]
 [events: 0000001f]
md: autorun ...
md: considering hdc2 ...
md:  adding hdc2 ...
md:  adding hda2 ...
md: created md0
md: bind<hda2,1>
md: bind<hdc2,2>
md: running: <hdc2><hda2>
md: hdc2's event counter: 0000001f
md: hda2's event counter: 0000001f
md: md0: raid array is not clean -- starting background reconstruction
md: RAID level 1 does not need chunksize! Continuing anyway.
md: raid1 personality registered as nr 3
md0: max total readahead window set to 124k
md0: 1 data-disks, max readahead per data-disk: 124k
raid1: device hdc2 operational as mirror 1
raid1: device hda2 operational as mirror 0
raid1: raid set md0 not clean; reconstructing mirrors
raid1: raid set md0 active with 2 out of 2 mirrors
md: updating md0 RAID superblock on device
md: hdc2 [events: 00000020]<6>(write) hdc2's sb offset: 4070976
md: syncing RAID array md0
md: minimum _guaranteed_ reconstruction speed: 100 KB/sec/disc.
md: using maximum available idle IO bandwith (but not more than 100000 KB/sec) for reconstruction.
md: using 124k window, over a total of 4038976 blocks.
md: hda2 [events: 00000020]<6>(write) hda2's sb offset: 4038976
md: ... autorun DONE.
md: Autodetecting RAID arrays.
md: could not import hdc2!
md: could not import hda2!
md: autorun ...
md: ... autorun DONE.
Adding Swap: 131312k swap-space (priority 42)
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
8139too Fast Ethernet driver 0.9.24
eth0: RealTek RTL8139 Fast Ethernet at 0xc281f000, 00:e0:7d:e3:c2:ec, IRQ 10
eth0:  Identified 8139 chip type 'RTL-8139C'
eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 45e1.
IPv6 v0.8 for NET4.0
IPv6 over IPv4 tunneling driver
eth0: no IPv6 routers present
